By knot points of the model


There is must be <Snap to 3D model> and <Geometry model visibility> enabled. For the point setting, indicate the pointer in the point setting zone on a model. After that will appear the required snap image f_clip0752 near the pointer, confirm the point setting by the left mouse button.

 

point51

 

Comment:        The point is constructed as the point projection on a current plane. It is possible to construct only projections of knot-points of a model. The point construction is possible in any convenient for work views (<Top>, <Isom> and so on).

 

point52

 

 

 

See also:

Point definition