Line construction in parallel to the required line on the required distance


  1. Indicate the line that is to construct the parallel cut:

 

line6-1

 

  1. Using the parameter panel set the distance between the lines:

 

f_clip0759

 

line6-2

 

  1. Select required line:

 

line6-3

 

  1. By the pointer indicate firstly the start position of the line, secondly the end position of the line:

 

line6-4

 

line6-5

 

As result we are have this line:

 

line6-6

 

 

 

See also:

Line segment definition