Contour construction by the chain of geometric objects


Construction by the chain of geometric objects mode is selected using the f_clip0730. The components of the profile are created using previously defined elements (lines and circles). A profile must start and end at predefined points.

To end the construction of a profile at the current point, press <End profile> f_clip0762 button. When <Close profile> f_clip0763 button is pressed, a closing element will be constructed and construction is finished.

Below you can see example of contour construction by the chain of geometric objects.

 

 

 

See also:

Contour construction modes

Example of contour construction by the chain of geometric objects