Contour drawing


Freeform drawing mode is selected using the f_clip0731 button. The elements of the profile are placed "by hand", the profile starts and ends at arbitrary points. The required type of profile element (line or arc) is defined by using <Continue by cut> f_clip0764 and <Continue by arc> f_clip0765 buttons.

To end construction of a profile at the current position, press the f_clip0762 button. When the f_clip0763 button is pressed, a closing element will be created, and the construction is finished.

Below you can see example of contour drawing.

 

 

 

See also:

Contour construction modes

Example of contour drawing