Contour construction on the set of points


Pressing <Profile by points> f_clip0732 button activates the contour construction on the set of points. When in this mode the management panel has additional buttons:

f_clip0769 – profile construction methods.

Over the defined multitude of supporting points, the following can be constructed:

  • f_clip0766 – <Profile - polyline>, supporting points are interconnected by line sections;
  • f_clip0767 – <Profile - spline>, supporting points are approximated by splines;
  • f_clip0768 – <Profile by arcs>, contour in which the creation points are connected by adjoining arcs.

To end construction of the profile at the current point, press the f_clip0762 button. When the button f_clip0763 is pressed, a closing element will be created, and construction ends.

Below you can see example of contour construction on the set of points.

 

 

 

See also:

Contour construction modes

Example of contour construction on the set of points