Hole capping


Quite often a geometrical model has holes the machining of which has been performed earlier or are required to be machined in a later operation. In this case, when machining the surface that has the hole, it can be ignored. The ignored holes can be of any shape (not always round). The defined size describes the diameter of a disk that can cover the hole.

 

Img5_4_36

 

Img5_4_36_2

 

 

 

See also:

Definition machining strategy

Job assignment for hole machining operation

Defining holes by coordinates

Defining holes by using a geometrical "point" object

Automatic hole recognition