Stock removal cycle (ISO G71/G72)


The roughing cycle generates one from both canned cycles ISO G71 or ISO G72 based on the defined profile. The cycle parameters can be defined in the properties window. Direction property switch between G71 and G72. If "Finish pass" check box is set then the finishing cycle ISO G70 is generated just after the rough cycle.

 

LatheContouringG71_

 

The extract from the Fanuc Operator's manual about cycles G71/G72 is shown below.

 

LatheContouringG71

LatheContouringG72

 

 

 

See also:

Lathe Machining

Lathe contouring

Types of the job assignment elements (cycles)