Positioning of part


After choosing a machine and after setting a capstan on it is necessary  to set up position of detail. As a rule, on lathe-milling machines  bodies of revolution are processing. Detail may be imported from CAD system, or setting by generatrix,  built in 2D geometry mode. If the detail is importing then its  generatrix restoring on 3D model base. This proсess does not always work correctly.  When errors exists, recommended to import  generatrix  as a curve and setup the detail with it.

Necessary to discriminate part coordinate system  and  machine coordinate system. Detail coordinate system attached to detail and e.g. rotate with the detail when a spindle was rotated. Machine coordinate system is shown in left bottom  corner of the screen when the machine is visible.

 

f_clip1052

 

When visibility of machine is OFF auxiliary axles  show a part coordinate system.

 

f_clip1053

 

At setup detail for processing on lathe machines necessary to align detail axle with X axle. There are two ways to do this: by moving the detail or by creating new local coordinate system. Routine is to set  an origin of coordinates on right butt of detail.

 

dbukclip23

 

For created coordinate system become a set, necessary to indicate it in machine parameters or active operation. After this the system will superpose zero points of part and machine.

 

f_clip1054

 

Machine zero point usually sets on a spindle nose. As result a detail will appear inside of machine. For a correct visualization  necessary to set a detail zero point in machine coordinate system.

 

PartPositioning2

 

 

 

See also:

Treatment at lathe-milling processing centers